 |
Programming by TV Manufacturer
- Locate the manufacturer's code for your TV from the TV code list
- Tum on your TV
- Press the "SET" key for three seconds until the LED illuminates, then release the key
- Enter the first manufacturer's code from the TV code list The LED turns off
- Verify the TV can be controlled by depressing the 1V power key
- If the TV turns off, tum it back on and verify that the Volume and Mute keys operate the TV
- If the TV cannot be controlled property, return to Step 1 and enter the next axle from the list You may have to perform this operation numerous times until correct operation of the TV is achieved
-
- If the above steps do not identify a code to operate the TV, perform the Code Search Programming Method below
Code Search Programming Method
- Tum on your TV
- Press the "SET" key for three seconds until the LED illuminates. then release the key
- Repeatedly press the CH▲ or CH▼ until the TV turns off
- Press "SET" key; the LED turns off
- Verify that the Volume and Mute function operate on the TV
- If they do not operate, perform Steps 1-5 until proper operation is achieved
TV Code Identification
If the code has been found by the Code Search Programming Method, the code that operates the TV can be identified as following:
- Press the "SET" key for three seconds until the LED illuminates. then release the key
- Press the "Info" key. The LED turns off
- Press "1" to obtain first digit; The LED flashes as many times as the number of the 1st digit
- Press "2" to obtain 2nd digit; The LED flashes as many times as the number of the 2nd digit
- Press "3" to obtain 3rd digit; The LED flashes as many times as the number of the 3rd digit
- Press "SET" key to exit code recall mode.· LED flashes twice
- NOTE: If the number is "0" the LED flashes 10 times
Restoring remote to factory settings
- Press the "SET" key for three seconds until the LED illuminates, then release the key
- Press and release in order the "9", "8" and "1" keys - LED flashes twice to signal remote reset
- NOTE: Whenever a programming sequence exceeds 5 seconds, the remote defaults to the previous settings.
|
