Skip to main content
Astound Broadband

Cisco 270/271

 

Manuals

  • Printable manuals -- 271 (HDA-RF 2.2, 270 (HDA-IR 2.2)
  • BOLT choice: Digital TV Adapter Remote (RDTARMT)
 
 

Identifying the 270 vs. 271

cisco271.jpg

These remotes are identical.

The model numbers are stamped on the back The 271 (IR/RF model) is listed as HDA-RF 2.2 The 270 is listed as HDA-IR 2.2

ciscoDTA_remote_difference.jpg

 

Auto-Search Programming (recommended)

cisco271.jpg
  1. Turn on your TV
     
  2. Point the remote control at the DTA
     
  3. Press and hold the Prog button for three seconds until the LED turns on
     
  4. Press and hold the [CH+] button search for codes
     
    • A new code transmits every 1.5 seconds, and the LED will blink for each one
       
  5. When your TV turns off, the remote control has found a valid code
     
  6. Press the TV button to store the code
     
  7. To test, press TV Power
 

Manual Programming Method

cisco271.jpg
  1. Find your device codes in the manual


  2. Turn on your TV
     
  3. Point the remote control at the DTA
     
  4. Press and hold the Prog button for three seconds until the LED turns on
     
  5. Press and hold the [TV] button. The LED will blink once and remain on
     
  6. Enter the code for your brand
     
  7. If the code is valid, the LED will blink twice and the code will be retained
     
  8. If the code is invalid, the LED will blink three times, and remain in programming mode. Try another code on the list
     
  9. Press the TV button to test. the TV should turn off
 

Pairing/Unpairing the 271 Remote - RF Mode

cisco271.jpg
Pairing the 271 Remote
  1. Press and hold the [Prog] button for three seconds until the LED turns on
     
  2. Press the [Info] key
     
  3. The LED on the remote will blink slowly indicating that the device is in pairing mode
     
  4. Enter the 3 digits the DTA shows on-screen The DTA will acknowledge the 3 digits entered was correct
     
Unpairing the 271 Remote
  1. Press and hold the [Prog] button for three seconds until the LED turns on
     
  2. Press 9, 8, 7

  3. The LED will blink 2 times quickly
 

Volume Control

cisco271.jpg

By default the remote controls the volume and mute on the DTA, not the TV

 

To control the volume and mute on the TV:

  1. Press and hold the [Prog] button for three seconds until the LED turns on
     
  2. Press the [Vol+] button

 

To control the volume and mute back to the DTA:

  1. Press and hold the [Prog] button for three seconds until the LED turns on
     
  2. Press the [Vol-] button