Skip to main content
Astound Broadband

RT-SR50 Simplicity

  1. Last updated
  2. Save as PDF

View printable manual​​

 

Programming TV using Code Entry Method

RT-SR50.jpg
  1. Turn on the TV
     
  2. Press [SEL/OK] and [MUTE] together until the indicator light illuminates
     
  3. Enter in the code for your TV:


     
  4. Enter EVERY code listed until your TV turns off
     
  5. Test the TV by pressing [MUTE]. If the TV turns back on, the programming was successful
     
  6. If your TV turns back on, press [SEL/OK] to lock in the code
     
  7. If the TV Does not turn on, enter the next code listed until the TV turns back on and press [SEL/OK] to lock in the code
 

Programming TV - Point and Press Method

RT-SR50.jpg
  1. Turn on the TV
     
  2. Press [SEL/OK] and [MUTE] together until the indicator light illuminates
     
  3. Press and hold [CH UP] until the TV turns off
     
  4. As soon as the TV turns off, release [CH UP]
     
  5. Test the TV by pressing [MUTE]
     
    • If the TV turns back on, the programming was successful. Press [SEL/OK] to lock in the code
       
    • If the TV Does not turn on, press [CH DOWN] until the TV turns back on and press [SEL/OK] to lock in the code
 

TV Code Readback

RT-SR50.jpg
  1. Press [TV POWER] and [SEL/OK] together until the indicator light illuminates
     
  2. Press [INFO] to identify your TV setup code
     
  3. The indicator light blinks back the code numbers with a 1-second interval between each digit
     
    • "0" Is indicated by 6 fast blinks
    • For example, 0-0-3-5 would blink back as:
       
      • 6 fast blinks
      • (one second)
      • 6 fast blinks
      • (one second)
      • 3 slow blinks
      • (one second)
      • 5 slow blinks
 

Programming Volume Control

RT-SR50.jpg The default volume control is done through the TV

 

To program volume control to your Cable Converter:
 

  1. Press and [CBL POWER] and [SEL/OK] together until the indicator light illuminates
     
  2. Press [VOL UP], then [CBL POWER]. The indicator light will blink and go out

 


To control the volume back through the TV:
 

  1. Press and hold the [CBL POWER] and [SEL/OK] together until the indicator light illuminates
     
  2. Press [VOL UP], then [TV POWER]. The indicator light will blink and go out
 

Batteries

RT-SR50.jpg Install two (2) new "AA" batteries as indicated by the diagram in the battery compartment.

 

When the indicator light becomes dim or no longer illuminates during use, batteries need to be replaced.
 

Memory Guard

RT-SR50.jpg This remote has Memory guard, which eliminates reprogramming after battery changes.
 

Resetting Your Remote

RT-SR50.jpg

To reset your remote to its default settings:

 

  1. Press and [CBL POWER] and [MUTE] together until the indicator light illuminates
     
  2. Press [1]. The indicator light will blink and go out