Pull back the remote control’s battery cover and remove it
Insert the two (2) supplied AA batteries according to the + and - marks in the battery case
Push the battery cover back into place
Test the unit by pressing any button
If batteries are inserted correctly, the Power button will flash red
NOTE: When batteries need replacement, the remote control will stop operating. Replace the old batteries
Setup - by Popular Brands
Turn on the TV or DEVICE you wish to program and follow the steps below to set up your remote for the most popular brands. Be sure to point the remote at your equipment during setup.
Press and hold the OK and MUTE keys simultaneously until the POWER key blinks twice
Press the letter key for the device type that you wish to set up
A = TV
B = Audio Device
Find your device and brand in the dropdown below. Press and hold the corresponding digit key while aiming the remote at your equipment.
Release the key when the device turns off and setup is complete.
Setting Up Using Code Entry
Turn on your equipment and follow the steps below to set up your remote. Be sure to point the remote at your equipment during setup.
Press the letter key for the device type that you wish to set up
A = TV
B = Audio Device
Press and hold the OK and MUTE keys simultaneously until the POWER key blinks twice
Using the digit keys on the remote, enter the code shown below:
Test the remote to confirm that it controls your device as expected. If it does not, try again using the next code listed
Setup - Searching All Codes
Turn on the TV or DEVICE you wish to program and follow the steps below. Be sure to point the remote at your equipment during setup.
Press and hold the OK and MUTE keys simultaneously until the POWER key blinks twice
Press the letter key for the device type that you wish to set up
A = TV
B = Audio Device
Aim the remote at your equipment and press and hold down the OK key
Release the key when the device turns off and setup is complete
Setup - Master Power Key
Press and hold the OK and MUTE keys simultaneously until the POWER key blinks twice
Press the Power key
Press each letter key that you wish to turn ON when you watch cable TV
A = TV
B = Audio Device
Press and hold the MUTE key until the POWER key blinks twice. Your new setting is saved.
Setting Volume Control
Press and hold the OK and MUTE keys simultaneously until the POWER key blinks twice
Press the VOLUME UP key
Press the letter key for the device you wish to use for volume control. The POWER key will blink twice to confirm
A = TV
B = Audio Device
Locking Input Switch to One Device
Press and hold the OK and MUTE keys simultaneously until the POWER key blinks twice
Press the INPUT key
Press the letter key for the device you wish to use for input switching. The POWER key will blink twice to confirm